port_prbs_monitor.sh drives PRBS on both 100G uplinks: lpmode off, arm
the pattern, then poll `phy diag <phy> prbs get` in the background until
stopped, counting a poll as PASS only when the output says "PRBS OK!".
prbsstat Ber is captured beside every poll for the record but does not
decide the verdict. `stop` runs prbsstat STOp and prbs clear before
rendering the report, so the test does not leave PRBS armed.
`start a` / `start b` runs one uplink alone, which is how a genuine port
fault is separated from the DUT not coping with two PRBS streams at
once. A port that was not run reports SKIP rather than FAIL -- deciding
on poll count alone would have made a deliberate single-port run look
like half the hardware was broken.
The port status is deliberately not printed at `start`: with PRBS armed
the link reports DOWN, which reads as a failure to anyone glancing at
the console. It appears in the report instead, after prbs clear and
labelled as the recovered state.
The calls in Script A, B and C are committed but commented out -- PRBS
is still under bring-up.
Fix: the job directory was written as /host/hw-eval/current/jobs in some
places and /host/hw-eval/jobs in others, so what Script B wrote was not
what Script C collected. Unified on /host/hw-eval/jobs.
Fix: Script C copied to /mnt/usb assuming it was mounted. It now finds
the device with usb_target.sh and mounts it first, so the logs actually
leave the DUT.
Script C also reorders its results -- stress logs, then the MGMT ping
report, then 100G status -- and cats the bgctl ssd/usb logs.
Script A -> V1.0.9. Docs and docs/release-notes/v1.0.9.md updated.
Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_014RetWKFZFG1ZHcitQAyhwM
